Acid Catalysed Lacquer
Fast Dry |
| SG / Coverage |
| 0.92 (mixed) / 7 square metres per litre |
| Low
Formaldehyde |
| Specially formulated to have low formaldehyde emission.
Equivalent to E1 standard – 80gms/sq. metre film drying for 14 days
at 20°C and 65% RH. |
| Pot
Life |
| Minimum 24 hours. Catalysed lacquer left overnight should
be adjusted for viscosity and mixed 1:1 with freshly catalysed lacquer prior
to use. |
| Application |
Standard products are suitable for application by Standard,
HVLP and Airmix spray systems.
Normally, two or more coats of the same material are applied, the exception
being the full matt lacquer where we recommend a basecoat of higher sheen
material is used to maintain clarity of finish.
Also suitable for curtain and roller coat application. |
| Drying |
Touch Dry: 10 - 15 mins
Re-coating: 1 - 11/2 hours
These times may be reduced by the use of force drying.
Packing: Overnight minimum |
| Thinners |
| Acid Catalysed Thinners: DT2004 |
| Cleaning
Fluid |
| Dual Thinners: NT2013 Use only for cleaning |
| Woodfiller |
| Nitrofilla |
| Stains |
Non Fade Ground Stain: Suitable
Waterstain: Suitable |
| Limitations |
Do not use over white or pastel shade enamels. A special
non-yellowing Acid Catalysed Lacquer is available for this purpose.
Do not apply over Polyurethane Lacquers or vice-versa, as severe yellowing
may develop on ageing.
Cherry and similar timbers can be prone to reddening when exposed to natural
daylight, which is accelerated by the presence of acid in glues and lacquers.
For these it is recommended that the acid ratio be reduced to 20:1.
Not recommended for use on horizontal working surfaces in laboratory, kitchen
or bar situations. |
| Packaging |
| Available in 6 litre pails containing 5 litres and 25
litre pails containing 20 litres (both having sufficient ullage for the
addition of the Acid Catalyst). Catalyst available in 500ml and 2 litre
plastic containers. |
Health & Safety |
| Refer to Health and Safety Data Sheet for individual products |
|
