Waterborne Standard Enamels |
| SG / Coverage |
| 1.1 approx / 7 square metres per litre |
| Activation |
| The above products, used as supplied, are suitable for most domestic furniture applications. Where improved durability is required, activator may be added to enamels prior to application (not necessary in primer). Add 4% Activator pre-mixed with an equal volume of water. Ensure the Activator is thoroughly incorporated into the enamel by thorough stirring, prior to use. Incomplete incorporation may lead to film defects on application. The addition of Activator will impart a pot life to the product and material should be used within 24 hours of activation. Any excess material left overnight may be thinned back within 24 hours of the original activation and used as a sealer. Reactivation is not recommended. |
| Application |
| Conventional Spray/Roller Coating/Vacuum Coating Apply as supplied HVLP Spray/Air Mix Spray/Dipping Thin with approximately 5% water prior to application |
| Drying |
| Touch Dry: 15 - 30 mins Sanding Recoating: 60 - 90 mins These times may be reduced by force drying. At temperatures below 15°C and high humidity, drying times will be extended and film formation endangered. |
| Thinners |
| Water |
| Cleaning |
| Water-clean equipment immediately after use. Consult Technical Service Department when changing from Solventborne to Waterborne for correct cleaning procedure. |
| Packing |
| Overnight minimum |
| Limitations |
| Not recommended for use on horizontal working surfaces in laboratory, kitchen or bar situations. |
| Storage |
| Protect from frost |
| Packaging |
| Available in 5, 25 and 205 litre containers |
Health & Safety |
| Refer to Health and Safety Data Sheet for individual products |
 |